Sink-Not 350
FLOTATION FOAM:
Seal and repair floating roof pontoons in hydrocarbon storage tanks.
INSULATION FOAM:
Double-wall tanks and vessels for LNG storage and transportation.
OIL RESISTANT FOAM:
Meets or exceeds requirements of ASTM D-471; MIL-P-21929B
FIRE RESISTANT FOAM:
Meets or exceeds requirements of ASTM D-1692; MIL-P-21929B
PIGMENTATION : None
COLORS : Standard amber
FINISH : NA
THINNER : Not normally required
CLEANER : Acetone, MEK, DOP or TFT BIO-SOLV
MIXING RATIO : 1.0/1.0 v/v
INDUCTION TIME : Not required
REACTION TIME – CREAM TIME :18 – 22 seconds / 77F
” ” GEL TIME : 80 – 90 seconds/77’F
SOLIDS BY VOLUME : >2,500%, (25-28X volume increase upon foaming)
FOAM GENERATION : Approx. 420 cu.ft. per two drum resin set
CLOSED CELL CONTENT : >90%
K FACTOR : 0.147 BTU-in./Hr./Ft2
APPLICATION METHOD : Deliver through plural pump with static mixer
STORAGE CONDITIONS : Normal, 40°F – 95°F in covered storage.
SHELF LIFE : 6 months after shipping under-protected storage conditions.
APPLICATION METHOD: Sink-Not #350 is engineered to be installed by pumping through hoses into the spaces being treated. Equal volumes of base and curing agent are metered from bulk containers such as 55 gallon drums then pumped through separate delivery hoses to an in-line static mixing device. The mixed resins are then fed through a single hose to a discharge nozzle for placement in the void spaces being filled. The mixed resin can be hosed in a stream as far as 10 – 12 feet. As the foam expands during cell creation and expansion it forces into leaks and small holes to form a perfect seal. Small residues of hydrocarbons are incorporated into the foam allowing intimate contact with steel surfaces. The cured resin is an almost perfect “closed cell” system which is highly resistant to saturation by liquids it contacts. The cured resin has been designed to be resistant to attack by all liquid hydrocarbons such as crude oil, gasoline and xylene. The minimum ambient application temperature is 25°F/-4°C. The SINK-NOT 350 components may be heated prior to spraying to reduce their viscosity. Drum temperatures should not exceed 110°F/43°C to avoid excessive internal pressures. Installation equipment exposed to mixed components is simply cleaned with MEK, Acetone or BIO-SOLV solvents. At the conclusion of each project all material lines are flushed with solvent.
CH-064 CASE HISTORY REPAIRS LEAKING PONTOONS ON DIESEL FUEL STORAGE TANK
CH-068 CASE HISTORY PROTECTS FLOATING ROOF PONTOONS IN CRUDE OIL STORAGE / TRANSFER FACILITY
DOWNLOAD SINK-NOT 350 PRODUCT DATA SHEET